The pool-service technician uses compressed air to blow through the lines. The distance from the booster pump riser to the outlet in the pool is approximately 25'. I have simple fitting I use with the air compressor that I can attach to the 1 1/2" pvc line to blow reverse ways to try and clear the blockage. After priming I just couldn't get it to suck. Equipment - Build, Use, and Repair. I tried a garden hose to backwash the line and could not see any water coming up in the skimmer. I'm basically having problems with my pump/filter system not having much suction power as indicated by very low return water to the jet in the shallow end, and very low suction at the bottom of the skimmer. When I turn the divert valves so that … Return line clogged? A clogged drain can make it impossible to keep the water in your pool clean and properly balanced. My pool is about 35 years old so I only have one suction line from the skimmer. Nothing It's clogged. These tight elbows can easily get clogged by any debris that flows past a dislodged strainer basket, and can also increase the risk that a drain cleaner gets stuck in the line. filters, though, have built-in breather tubes that integrate into the top manifold assembly and exit through the discharge line.
I have simple fitting I use with the air compressor that I can attach to the 1 1/2" pvc line to blow reverse ways to try and clear the blockage. Pumps, Filters, and Plumbing. My pool is about 35 years old so I only have one suction line from the skimmer. A breather tube automatically purges air trapped at the top of the filter. if dirt is escaping back into the pool, it could be because the filter is dirty and clogged, which means it needs to be backwashed.
Equipment - Build, Use, and Repair.
Important: swimming pool drains are often built with short radius elbows that are normally found in cold water supply lines.
The pool itself is old, I'd guess around 40 years or so. Be careful to get the o-ring back in place before reinstalling the screws and don't overtighten. I thought the pump was bad and rebuilt it, to no avail. On here it says that a snake will clean it but my pool people say that will not work because of the 90 degree fittings. Some of the D.E. Typically, the tube runs from just under the dome to the bottom of the tank. May 30, 2013 4. May 30, 2013 #1 We just opened our pool a week ago and have no flow at the returns. Clogged or pinched return line? Pool drains get clogged from time to time, even if you properly care for and maintain your pool.It's part of pool ownership, and you have to maintain the drains to avoid bigger problems down the road.When they do get clogged, you have to unclog them.
Copyright 2020 pool return line clogged